Pacific Internet - Ukiah, California

Comtrend VR-3030 Modem

Comtrend VR-3030 Modem

This guide will instruct you how to configure the Comtrend VR-3030 modem to work with Pacific Internet DSL.

Step 1 – Login

Connect your computer to the Comtrend VR-3030 modem. Open a web browser and use the address bar to navigate to the address 192.168.1.1. You should receive a login prompt, similar to the image below. Use the following default login information and then click OK:

  • Default username: root
  • Default password: 12345
Comtrend VR-3030 Login Prompt

Step 2 – Interface Setup

Comtrend VR-3030 Basic Setup Button

Once logged into the modem, along the top will be a navigation bar. Click on the Basic Setup button (example to the left). Here, we'll be setting up interfaces for the modem to use when synchronizing the DSL signal. The modem will be configured as a network bridge.


Step 2a – ATM Interface

Set the drop down menu to ATM Interface and then click Add.

Comtrend VR-3030 Add ATM Interface

The below settings will appear. Review the configuration and then click Apply/Save.

Comtrend VR-3030 ATM Interface Settings

Step 2b – PTM Interface

Set the drop down menu to PTM Interface and then click Add.

Comtrend VR-3030 Add PTM Interface

The below settings will appear. Review the configuration and then click Apply/Save.

Comtrend VR-3030 PTM Interface Settings

Step 2c – Verify Interfaces

Once complete, you should see the following under the Layer 2 Interface:

Comtrend VR-3030 Interfaces

Step 3 – WAN Setup

Next, we'll set up the WAN so that the device connected to the modem can be assigned an IP address. Click on Add to set up the WAN service.

Comtrend VR-3030 WAN Setup

Step 3a – ATM WAN

  1. Select the ATM interface and click Next
  2. Select Bridging and click Next
  3. Click Apply/Save
Comtrend VR-3030 ATM WAN Setup

Step 3b – PTM WAN

  1. Select the PTM interface and click Next
  2. Select Bridging and click Next
  3. Click Apply/Save
Comtrend VR-3030 PTM WAN Setup

Step 3c – Verify WAN Setup

Once complete, you should see the following listed under the WAN setup.

Comtrend VR-3030

Configuration Complete!

Now that the Comtrend VR-3030 modem is configured, you can close your web browser to exit the configuration. Connect your router to the modem, if you're using one, and you're ready to go.